| ||
| Overview | Before marking out the lamp aperture hole pattern, I scribe the panel lines in the target board first. Check the image I sent down with page five which shows clearly how the target board appears to be made up of three separate panels. The easiest way I have found to scribe a single line to represent these panel lines should be well clear in the image attached - 3751. Be sure your vice jaws are either smooth, as mine are, or if you are using jaws with a serrated surface, use smooth jaw protectors, otherwise your work piece will be shot and you'll have to make another
| |
[Page1][Page 5][Page 10][Page 15][Page 20] Last updated : November 18, 2007 13:01
| ||
